3 in stock
3/4 width rock and roll bed, made from 20x20x2.5mm box section, with all the brackets/hinges CNC laser cut. This bed sits level with the rear engine shelf and makes up a 6-foot (183cm) bed when out in bed position. The frame is fully powder coated black and comes with all fixings needed to assemble it, it also comes with 9mm ply boards ready for trimming. Operates easy from seat to bed mode in just a few seconds.
– Width 1050mm (3/4). Full length (1460mm) is available with code SK100816
– Fits to rear wheel arch on one side and to the bulkhead the other side
– Fully powder coated in black
– Designed to take 4 inch (10cm) foam
– Base of seat lifts up for storage under the bed
NB: The bracket to be fixed to the body or wheel arch is pre-bent to suit the majority of uses, it might be necessary to adapt the angle according to the fixing point.
