3 in stock
Turn your existing cooler into a real compressor refrigerator with this cooling unit! The installation is simple. Everything you need is already included.
No special tools required.
The compressor is quiet enough to be mounted in a cabinet, on the floor or on the wall with an L-bracket (not included) as long as you provide good ventilation.
Compressor and evaporator are connected with a 2-metre hose equipped with quick-release couplings: you can connect it without losing refrigerant.
– Compact, air-cooled unit
– Transforms your cooler compartment into a refrigerator
– Easy to install
– Mechanical control thermostat with wheel to be placed outside or inside the refrigerator
– Danfoss / Secop 12V / 24V compressor
– Evaporator: Small – flat
– Evaporator dimensions H x L (mm): 350 x 130
– Compressor dimensions H x L (mm): 280 x 160 x 175
– Maximum refrigerator volume (litres): 60
– Average consumption: 0.6 / 2.7 A
– Weight (kg): 9
CAUTION: When installing the refrigerator carefully follow the installation instructions. If in doubt, consult a professional installer.
The conventional cooling system uses air that is conveyed by a fan into the condenser. It is therefore important that the compressor room is well ventilated,
so that cold air can flow in from the lower part and warm air can flow out from the upper part.
The capacity of the battery should be at least 75 Ah so that sufficient energy can be stored during engine operation. All electrical equipment such as the alternator,
the regulator, the cables, the connectors and the batteries must be in good condition.
Use power cables of the correct size depending on the distance between the battery and the compressor. If a breaker is to be installed, it must be able to withstand a starting load of 15 A.
Excess hoses cannot be cut off, otherwise the refrigerant they contain will escape. They must therefore be coiled, taking care not to crush them.
For installation, it is necessary to drill a 30 mm hole in the wall of the refrigerator and in any external bulkhead for the passage of the hose and evaporator connections.
